The FPD3300 Series positive
displacement flowmeters are
affordable and accurate. One
primary feature is the ability to
maintain consistent accuracy
despite changing viscosity
conditions. The meter’s solid
construction and excellent dynamic
response are well suited to the
measurement of many solvents
as well as other non-abrasive
lubricating fluids. Since there is
no need for straight run piping
upstream or downstream of the
flowmeter, the FPD3300 flowmeters
are simple to use and to install. The
meter has good resolution and high
accuracy at low flow rates.
Specifications Accuracy: ±0.5% of reading, ±1.0% of reading (¼" models) Repeatability: ±0.03% Fitting Type: NPT: Female BSP: “-BSP” option DIN: “-DIN” option JIS: “-JIS” option ANSI: “-ANSI” option Hall-Effect Sensor Power: 4.5 to 24 Vdc (7.5 mA) Reed Sensor Power: 30 Vdc (500 mA) Output Options: Pulse Output: Standard 4 to 20 mA Transmitter: “-D-A” option; no output on battery powered “-D” model Display: 7-digit/12 mm (0.47") upper, 7-digit/7 mm (0.28") lower all, “-D” options Rate: User defined Total: Resettable Accumulated-Total: Non-resettable Minimum Viscosity: 1 cPs Maximum Viscosity: 1000 cPs standard Maximum Pressure: See chart on page F-3 Strainer Size: See chart on next page Mounting: Shafts must be in a horizontal plane Electrical Connections: 2 x 12 mm (0.08 x 0.47"), fittings included “-D-A” option Cable Length: 1 m (3') stripped ends non-display models Mounting: Pipe Power: 4 to 20 mA, “-D-A” models 18 to 30 Vdc display, “-D” models 3 Vdc lithium battery (included) Liquid Temperature: -40 to 80°C (-40 to 176°F) Materials Body: Aluminum Enclosure: Polypropylene Seals: FEP Rotors: Stainless steel Fasteners: Stainless steel Cable Insulation: PVC Enclosure: NEMA 6 (IP67)
All dollar amounts on this site are shown in Canadian currency.Note: Comes complete with lithium battery and operator’s manual.
For units with a battery powered digital display add “-D” to the model number, for an additional charge.
For units with a DC powered digital display and 4 to 20 mA output add “-D-A” to the model number, for an additional charge.
For units with BSP connections add “-BSP” to the model number, no additional charge.
For units with DIN flanges add “-DIN” to the model number, for an additional charge (1" and larger only).
For units with JIS flanges add “-JIS” to the model number, for an additional charge (1" and larger only).
For units with ANSI flanges add “-ANSI” to the model number, for an additional charge (1" and larger only).
For units with high viscosity rotors (Up to 1,000,000 cps), add “-HV” to the model number, for an additional charge.
Oval Gear Flowmeter w/Pulse Output or Digital Display
12mm LC Digital Display with Analog Output Options