The FW1000 Series has been discontinued. Please see the FMG90 Series as a possible alternative or contact our Flow Engineering Department.
The FW1000 series are minimally invasive,
low-cost segmented wedge flow sensors. The
segmented wedge element provides a simple
and reliable restriction for sensing flow as related
to pressure differential. The FW1000 design allows
users to install the meter in any full pipe orientation
(horizontal, vertical or inverted). It is compact and
rugged measuring less than 254 mm (10") long and
89 mm (3½") wide, with a flanged mounting base for
simple installation. This series is offered with several
ranges of calibration to accommodate the
requirements typical to process water applications.
Three standard NPT port sizes are available to
accommodate installations. The standard unit can
also be converted to a 1 to 10 Vdc output in the field.
SPECIFICATIONS Accuracy: ±2% of full-scale Repeatability: ±½% of full-scale Maximum Operating Pressure: 8.6 bar (125 psig) Maximum Operating Temperature: 76°C (170°F) Standard Test Media: Tap water @ 21°C (70°F) Electronic Output: 0 to 5 Vdc (standard), 4 to 20 mA (optional) Power Requirements: 12 to 35 Vdc Flow Measuring Range: 0.5 to 15 GPM (1.9 to 57 LPM) full-scale Turn Down Ratio: 10:1 Maximum Current Consumption: <50 m ADC Minimum Load Resistance: 1000 Ω Maximum Transmission Distance: <61m (<200') Resolution: Infinite Response Time:<500 mS to 90% (step change) Protection: Short circuit, transient and reverse polarity End Ports: PVC Wedge Element: PVC Pressure Sensor: Polyetherimide Electrical Enclosure: Polycarbonate
Most Popular Models!
All dollar amounts on this site are shown in Canadian currency.Note: Comes complete with operator's manual. Ordering Example: (1) DPF64 Digital rate meter, CAD389.00 plus (1) FW1210 Wedge flow ½ NPT 1 to 10 GPM, CAD820.00 plus (1) TX4-100 Multi conductor wire, CAD44.00, CAD389.00 + 820.00 + 44.00 = CAD1,253.00
Part Number Builder
Build Your Part Number Below
Fittings select from: 1 for 3/8 NPT 2 for 1/2 NPT 3 for 3/4 NPT
Range select from: 05 for 0.5 to 5 gpm 10 for 1 to 10 gpm 15 for 1 to 15 gpm
Output select from: Nothing(leave field blank) for 0 to 5 Vdc -I for 4 to 20 mA
Note: All combinations may not be valid, check spec sheet for valid part numbers.