Appelez-nous au 1-888-826-6342
Bending & Axial, Full Bridge Strain Gauges with Transducer Quality
3.2 mm Grid Length, 3.2 mm Grid Width 350 Ω Resistance, ST STC Number
Remises de volume disponibles
Calendrier de remise sur volume
| Quantité | Prix unitaire |
|---|---|
| 1-4 | C$254.71 |
| 5-9 | C$241.97 |
| 10-24 | C$236.88 |
| 25-49 | C$226.69 |
| 50-99 | C$221.60 |
| 100+ | C$216.50 |
Ajouté à votre panier
Configuration terminée.
Veuillez ajouter au panier pour la conserver ou quitter la configuration
Veuillez ajouter au panier pour la conserver ou quitter la configuration
Échec de l'enregistrement des configurations, cliquez sur le bouton Configurer Recommencer
- Conveniently Priced per Pack of 5
- Rugged, High Reliability
- Flexible, Small Bending Radius
- Broad Temperature Range
SGT-3G/350-FB11 Options de modèles
Voir tous les modèlesModifiez ces spécifications pour commander un modèle différente. Toutes les combinaisons ne sont pas valides. Les options compatibles avec les sélections précédentes seront en gras.
*Les options en surbrillance ne sont pas compatibles. Veuillez sélectionner une combinaison différente.
Grid Length Range
Grid Length
Grid Width
Connection Type
Resistance
STC number
Grid Style
Temperature Range Units
Temperature Range Min
Temperature Range Max
Maximum Strain
Features
OMEGA™ transducer quality strain gages are available in a variety of patterns to cover most transducer design requirements. Their rugged construction, reliability and flexibility make them suitable for highly accurate static and dynamic transducers. The measuring grid is formed by specially formulated etching constantan foil, which is then completely sealed for long term reliability in a carrier medium composed of polyimide film.
Rated 4 out of
5
by
Anonymous from
epoxy on solder pads adds difficulty
Gage performs, but I had to scrape the pads in order to solder lead wires on. They were covered in a thin layer of epoxy that prevented soldering. And this was prior to bonding so it wasn't from the installation process.
Date published: 2021-05-29
What is the resistance tolerance for each element?
Tolerance on the 350 ohm resistance is +/- 0.5%
Date published: 2020-10-01
What's the tolerance for the 1K resistance?
Thank you for your inquire
all specification are listed on the website.
Please direct these questions to the pressure group at pressure@omeg.com
as the specs do change from time to time
Date published: 2020-10-02
What is the full-scale signal voltage output at the maximum excitation voltage of 6.5V?
The full scale output will depend on the gage factor and the actual strain applied. Please see page E-104 full bridge configurations in the following link for the formula to compute your mV out and strain.
https://www.omega.co.uk/techref/pdf/StrainGageCalcs.pdf
Date published: 2023-08-09
What is the GF for these sensors?
Thank you for this inquire
The Gauge factors on these are nominally 2 Each package when received will have its own number.
Date published: 2023-04-20