Un ensemble de thermocouple qui peut être facilement monté à de multiples surfaces. Parfaitement adaptable à plusieurs appareils de mesure de température en surface sur lesquels le montage fixe est possible.
EXEMPLES DE MODELES COURANTS CI-DESSOUS. VEUILLEZ UTILISER LE TABLEAU CONSTRUCTEUR DE REFERENCE POUR TROUVER LES MODELES SPECIFIQUES QUI SONT DISPONIBLES.
Pour les spécifications complètes des produits, veuillez consulter la section "Liens associés" en bas de page.
Dimensions de la rondelle M3,5 et M4 : L 22 x L 6,5 mm M4,5 et M6: L 25 x L 9 mm
What is the outer diameter of the wire with PFA insulation?
Asked by: JDCT
The overall nominal outer diameter of the PFA lead wire for the WT series is 0.068 x 0.116".
Answered by: ANB ENG
Date published: 2020-05-10
1. Where is the thermocouple measurement made? Can you cut off the bolt hole without affecting the performance?
2. Are these made in an un-bent configuration?
Asked by: bchynoweth
Thank you for the inquiry. The thermocouple tip ( sensing portion of the TC) is pressed within the washer. You will notice the small channel on the shoulder of the washer. You could cut off the bolt hole being careful not to cut in to the channel.
We do not offer a flat version.
Answered by: AENorwalk3
Date published: 2020-04-23
Are any of these t/c made with stranded wire? I need something that is flexible. If so, what is the Dynamic Bend Radius?
Asked by: Greg B
These are all made with solid wire. Please use 3 x wire diameter for minimum bend radius. Thinner wire will hold up longer. You might consider the SA1-K or the SA1XL-K as alternate.
Answered by: AENorwalk
Date published: 2020-04-09
What is meaning of Minimum Temperature Measurement - 60 in
Asked by: Bobble
The heading is incorrect for the column and should read "Lead wire length" and it will be corrected.