Note: These Sensors Require an M12 Extension Cable to Connect the Sensor To Your Instrumentation. A Partial List Of Our M12 Extension Cables is Included in the Ordering Table Below.
This Pt100 RTD sensor is designed for use in sanitary or Clean-In-Place (CIP)
applications where the use of a thermowell
assembly is preferred over direct immersion sensors. The thermowell includes a 1½", 16AMP
cap feature for easy installation using industry standard gaskets and clamps
. The spring loaded RTD probe can be removed from the thermowell without exposing the system to ambient conditions
for calibration or replacement. This sensor includes a 4-Pin, M12 Connector for easy installation using an extension cable. Sensor Specifications Include: 316L stainless steel process wetted surfaces with surface finishes of 32 microinches or better. Immersion lengths of 15⁄8, 2½", 4½", 7½, and 10½" are available from stock, with others available. Sensor Output is a 4-wire, 100 ohm, Class A, Platinum RTD meeting the requirements of IEC 60751. These sensors can be used with 2-wire or 3-wire systems see information below. Insulation resistance values of 100 megohms minimum at 100 VDC.
These sensors are supplied standard as 4-wire assemblies with 4-pin connectors.When used in 3-wire applications
, use pins A, B and C as shown in the wiring detail below. When used in 2-wire systems
, connect one wire to pins A or B, and the other wire to pins C or D as shown below.
|Wiring Diagram |